Question 1

How is Endurablend™ installed?

Accepted Answer

Endurablend™ is installed using specially designed mixing and placing equipment by certified Endurablend™ installers. Depending on the size of the job, which can vary from a bridge deck, or cycle path to a large airport apron, or even a roadway, the installer will establish a planned closure, prepare the asphalt or concrete surface, place the Endurablend™ (spray or squeegeed) in a designed configuration (color, texture, pattern and finish modification) and remove the closure.

Question 2

Can an Endurablend™ System be installed in snow plow climates?

Accepted Answer

Yes, Endurablend™ Systems have been installed for over five years in areas where snow plows are frequently used. Because of Endurablend™’s durability and thin application, the Endurablend™ surfaces are unaffected by snow plows.

Question 3

Can Endurablend™ Systems be installed in any location?

Accepted Answer

Yes, Endurablend™ Systems can be installed in busy urban areas or in remote locations. The mixing and staging can be performed on a flatbed in the traffic lane directly in front of the placing unit, or at a staging area in close proximity to the job site. The mixing and placing operation can be tailored with the assistance of PSC or its installer for just about any job.

Question 4

Who can install Endurablend™ Systems?

Accepted Answer

Pavement Surface Coatings and is setting up a network of installers across the world. If an installer is not set-up in the area where a project is identified, PSC will work diligently to locate installers or, if logistics and schedules permit, PSC will undertake the Endurablend™ Systems installation.

Question 5

What are the optimum installation conditions for Endurablend™ Systems?

Accepted Answer

The standard minimum recommended ambient air temperature needs to be 50° F and rising. The optimum environmental conditions for installing the material is 68° F to 86° F with relative humidity (e.g. 50%) which will result in a curing time of 2 hours or less. Under such conditions the section can be opened to traffic in less than 2 hours. The maximum recommended ambient temperature for installation of Endurablend™ systems is 95° F. For conditions that are outside these recommended boundary conditions, the mixing and placement operation needs to be tailored by Pavement Surface Coatings.

Question 6

Can Endurablend™ Systems be applied on newly laid asphalt or newly applied crack filler?

Accepted Answer

Yes. It is recommended that the asphalt surface or crack repair material be allowed to cure for at least 2 weeks before installing Endurablend™ Systems. This allows the surface volatiles to evaporate or be removed by traffic to prevent tracking on the decorative systems.

Question 7

Can Endurablend™ Systems be applied over aggregate surfaces?

Accepted Answer

Yes, depending on the nature of the aggregate system. Endurablend™ has been successfully installed over conventional high friction surfaces of epoxy/aggregate improving aesthetics and performance.

Question 8

How is Endurablend™ Systems applied over asphalt or concrete surfaces that exhibit thermal, longitudinal, lane widening, or construction joint cracking?

Accepted Answer

Where discrete cracking exists on the road surface, it is recommended to mitigate the effects of the cracking by treating the cracks appropriately by cleaning and routing and then applying an Endurablend™ pretreatment layer. After this treatment has cured, the application of the designed Endurablend™ System can proceed.

常见问题

产品的问题

安装问题

地址

©2019路面表面涂料。版权所有

应用

快速菜单

安装人员

跟美国